![]() ![]() The risers simply screw into the pre-drilled holes in the case. Their job is to hold the motherboard off the bottom of the case, so it isn’t shorted out when its contacts touch the metal. These will be included with the case and look like tall copper screws. You need to fit risers where you noted the screw holes. ![]() Take a note of where the screw holes in the motherboard go, and remove the board. Make sure that its rear ports are pushed up against the blanking plate correctly. When you’ve got a clear case, take the motherboard off its foam backing and slide it gently into the case. Lie the case flat on the desk and make sure that all the internal cables are out of the way. Next, you need to see where the screw holes for the motherboard will go. It should, however, clip into place and remain stable without any support. Be warned that this can be really fiddly and the blanking plates don’t always fit perfectly. The ridge around the outside of the plate should clip into the hole. Remember to align it so that it’s the same way up as when you measured it against your motherboard. Install the blanking plateįrom the inside of the case, you need to take the blanking plate and push it into the gap at the rear of the case. Make sure that you bend it far enough for the motherboard’s port to be given enough clearance to pass underneath. In this case, the flap should be bent inwards (towards where the motherboard will be). Second, some ports may be covered by a flap. These should be rocked gently out until the metal snaps. First, you may have to remove a bit of metal, in a similar way to the metal blanking plates on your case. If you need to remove any parts of the blanking plate, you should do that now. Make a note of any ports that are covered. It will only fit one way, so maneuver it until it’s the right way. The blanking plate should be pushed against the motherboard with the ridge pointing out, so any text is readable. The easiest way to see is to hold the blanking plate up to the motherboard until the cutouts match the ports on your board. With these, you may need to remove some metal covers to give access to your motherboard’s ports. However, some motherboard manufacturers use generic blanking plates that fit their entire range of boards. The blanking plate fits into the case and gives you access only to the ports that your motherboard has. Place the motherboard and foam on top of the anti-static bag, and take out the metal blanking plate. Slide the motherboard out of the bag, but leave it attached to the foam for now. The motherboard will be inside an anti-static bag and resting on top of anti-static foam. Take these components out and put them to one side, as you’ll need them later on. You’ll see lots of cables, a driver CD, a metal blanking plate with holes cut out and a manual. Using rubber gloves (no powder) prevents any oils from your hand damaging the components while an ESD band or mat will prevent static electricity damage. However, some of us feel it’s better to be safe than sorry. Again, some seasoned users say they’ve never used ESD bands or mats and have never had an issue. We’re talking about your motherboard’s safety. Now, consider safety – We aren’t talking about your safety (of course it’s a good idea to make sure your power supply isn’t connected to anything to avoid an electrical shock). A Phillips Head screwdriver, tweezers, and even small zip ties are things you don’t want to look for while holding the motherboard in place. Next, gather your tools – Another likely obvious tip for seasoned individuals, gather and organize the tools you’ll need. Of course, it’s probably obvious to move any liquids or clutter, but a dust-free environment is optimal. Exposed mechanical components are sensitive to particles in the environment. If you want the process to go smoothly, there are a few things you can do before ever unpacking the motherboard.įirst, prepare your workspace – This means cleaning your workspace to ensure that it is free of any dust or debris. The motherboard is the backbone of your entire PC, connected to every other component, so it’s vital that you get things right now to avoid trouble further down the line.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |